for Many of Our L.I. Sound
Offerings—
Discounts Available on Top Quality Marine
Batteries. All sizes, Deep Cycle and Cranking
Example-
Group 27
Deep Cycle
Our Price: $89.95
Free Local Delivery in Milford or
Stratford!
Solid Teak Dorade Box
Add ventilation in the form of beauty. As
seen on Hinckleys, Bristols, Little Harbors and so many other
top quality yachts.This dorade box has a baffle inside to help
keep out rain and spray. Opening for drainage. Ready to be cut
for whatever size cowl vent you want to install up to 4”
diameter. Add a stainless steel cowl vent, then trim to deck
angle (if necessary) for best look. Overall size measures
16" X 7" X 5 3/8"
List Price: $134.95 Our Price: $109.95
Finish yourself or we’ll...sand it,
detail-prep it, seal the outside surface, and brush on an
additional 5 base coats of varnish (with hand detail sanding
and prep between all coats): $339.00.
Or, buy a matching pair and save: $499.00/pr,
finished.
(Note: After installation, you’ll
still want to add a few more coats yourself.
A minimum of 8 coats is recommended.)
Buying or Selling?
Visit the extremely
likeable guys at
in Milford, CT. All brokers are NOT
created equal. These guys will go the extra mile for you. We
highly recommend them!
Other Friendly
Local Marine Links:
White 30 Amp/125 Volt Shorepower Cord Set
Replace that ugly yellow industrial-looking
power cord with a nice new white one by Charles, a leader in
marine industry electrical products. Adds to the overall
presentation of your vessel dockside, with a clean, unobtrusive
look. And, after a year or so, it’s still white, not pale
faded yellow. Cleans up easily. These cord sets are top-quality
marine grade. They have a lifetime warranty Standard 30 amp
fittings for dock and boat. Plug-and-screw onto boat,
plug-and-twist-lock at dock receptacle. Exceeds ABYS standards.
25' Cord List Price: $69.99
Our Price: $57.95
50' Cord List Price: $79.99
Our Price $69.95
Bristol Finish, Lasts for Years, Not Just a Few Months.
Long lasting, two part urethane wood finish
with the look of a high gloss clear spar varnish. Allows beauty
of wood grain to show through. Can be recoated in a couple
hours, without sanding between coats. (Though, for best
results, some sanding is recommended for top coats.) See Bristol
Finish section on our Brightwork page for more info
about this great product.) List Price $59.95
Quart Kit List Price: $59.99
Our Price: $58.95 each
2 or more Qts. Our Price $55.95 each
Teak Handrails for
above or below deck. Lengths to 6'/7 Loops
10 1/16" center to center of loops
(except single loop version @ !0 5/16"). Unlike others,
these come with teak plugs/bungs for coverage of mounting
fasteners. Unfinished, high quality burmese teak. Finishing
available to your specs. Email or call for rates.
dakotamarineys@aol.com
1 Loop, 13 x 2 3/8 x 1 List Price: $15.99
Our Price
$14.79/ea $28.99/pr
2 Loops 23 x 2 3/8 x 1 List Price: $23.99
Our Price $21.99/ea $42.99/pr
3 Loops 33 x 2 3/8 x 1 List Price: $27.99
Our Price $25.99/ea $49.99/pr
4 Loops 43 x 2 3/8 x 1 List Price: $36.99
Our Price $ 33.99/ea
$65.99/pr
5 Loops 53 x 2 3/8 x 1 List Price: $51.99
Our Price $ 46.99/ea
$89.99/pr
6 Loops 63 x 2 3/8 x 1 List Price: $69.99
Our Price $ 61.99/ea $119.99/pr
7 Loops 73 x 2 3/8 x 1 List Price: $89.99
Our Price $ 79.99/ea $157.99/pr
(7 Loops/Special Order)
Bilge Water Filtering System, A Sound Solution for Every Boat.
This one is a must for you, your kids,
their kids and the environment you enjoy so much! Oil, gas, or
diesel fuel will inevitably find its way into the bilge.
Pumping it out through your bilge pump is illegal. The DEP can
slap you with a $5000 fine! But, more importantly, protecting
the environment and those close to you who will use these
waters in the future, should be a top priority. It’s our
responsibility today. Here’s a great way to start.
These Centek
Bilge Water Filtering Systems are well-designed, extremely
efficient and easy to install. They filter out virtually 100%
of gas, oil and diesel fuel, or any other hydrocarbon from your
bilge discharge line through a revolutionary product called
MYCELX, a polymeric surfactant technology. And there is no
pressure build-up created at all so discharge is as
unrestricted as if there were no filter. Beautifully designed
in both appearance and functionality, there is a model
available for your boat. (We can install it for you if you are
local.)
8-MBK-1 is primarily for smaller, ski boats
and runabouts.
List Price: $117.99 Our Price $109.95
8-BK-1 10”/20 GPM (for use with
1200 GPH Bilge Pumps or Less).
Includes bracket, hose barbs, SmartPad.
List Price: $139.99 Our Price $127.95
8-BK-2 10”/60 GPM (for use with
3600 GPH Bilge Pump or Less) 1 1/2” NPT
Includes bracket, spanner wrench, SmartPad.
List Price: $276.99 Our Price $349.95
8-BK-3 20”/60 GPM (for use with
3600 GPH Bilge Pump or Less) 1 1/2” NPT
Includes bracket, spanner wrench, SmartPad.
Centek MYCELX BilgeKleen Replacement Filters
Filters are easily replaced and should be
changed 1-2 times per season, depending on type and usage of
vessel. Check every 3 months.
For 8-MBK-1 List Price: $48.99 Our Price $45.95
For 8-BK-1 List Price: $55.99 Our Price $51.95
For 8-BK-2 List Price: $75.99 Our Price $69.95
For 8-BK-3 Call for
Pricing
Stainless Steel Step Pads with Black Vinyl
Insert
Attractive and functional solution for
protecting your freshly varnished cap rail with sure footing
where everyone steps on board. Or use on boarding steps for
sure footing. Many other uses possible. Mount easily with two
or four screws depending on step size. Two sizes available.
Won’t pit like inferior chrome plated versions. Packaged
in pairs.
Sm. 8 3/8 x 2 1/4 List Price:
$25.40 Our Price: $19.95/pr
Lg. 8 7/8 x 3 3/8 List Price:
$29.99 Our Price:
$23.95/pr
Size
Sm
M
Lg
A
5 1/4"
7"
8 1/2"
B
4 1/2"
7"
8 1/2"
C
5 1/4"
7"
8 1/2"
D
5 1/4"
7"
8 1/2"
